Cyclops Remote Alarm
This remote control alarm is operated by multi code remote control. Entry point protection of doors, boot and bonnet with a shock sensor. Audible warning is achieved via a standard 115dB siren, visually via the vehicle indicators and via a dash mounted high intensity red LED. The system may provide keyless entry and a source of immobilisation.
 Operation |
- Arming procedure while ignition is off
The system will arm immediately if the main button of a valid remote control is momentarily pressed, the doors will lock and all security functions will become active  .
- Disarming procedure
The system will disarm when the main button of a valid remote control is pressed.
| Immobilisation |
- Independent circuit of immobilisation
30 Amp rated, normally closed contacts.
- Automatic immobilisation
39 seconds after ignition switch is turned off.
- Safety circuitry incase of power failure
System sources alternate power from ignition if main power is lost.
| On-board relays |
- Protection against harsh road conditions
All relays are fully encapsulated to provide protection against dust and moisture.
| Controllers |
- System memory
Allows system to track two controllers.
- Controller re-programming
Service technician can delete lost or stolen controllers from memory.
- Remote battery life
The 27a 12 volt 20mAH alkaline battery has a expected average life span of between 6 and 12 months (depending on usage). Battery manufacturer may vary due to availability of stock. See the GP battery manufacturer website.
| Wiring |
- Plug and play for service
Designed to allow easy access for service technicians.
| Override |
- Emergency Personal Identification Number override
Enter the secret four digits to override the immobiliser  .
- Alterable PIN
Users can change the numbers of their secret override PIN .
| Visual Output |
- Super bright red dash LED
This LED flashes to inform user when system is armed. The LED is mounted on the driver's side dash and is visible from outside the window.
- Arm/Disarm confirmation
System flashes car indicators when arming or disarming.
- Alarm illumination
System flashes car indicators when thief triggers alarm.
- Trigger diagnostics
System will flash indicators to report the last triggered circuit.
| Audio Output |
- Standard siren
Uses standard two wire 115dB siren.
- Arm/Disarm confirmation
System sounds a siren when arming and disarming .
- Temporary arm/disarm chirp disable
Momentarily press the second button of the remote control before pressing the main button, the siren will not chirp during that one operation.
| Intrusion Detection |
- Doors, bonnet and boot monitoring
Triggers alarm system if intruder opens any protected entry point in vehicle .
- Accepts plug-in single stage shock sensor
Sensor measures vibration subjected to vehicle to detect intruder, SEN-002.
| Central Locking |
- Locks and unlocks all doors
System can trigger factory central locking, aftermarket central locking or central locking relays  .
- Variable pulse time
Extend pulse length to drive pneumatic central locking systems (Mercedes) .
- Automatic re-locking
System will re-arm and re-lock doors if previously disarmed by remote control and doors remain closed .
- Anti-hijacking protection
System locks doors when ignition is turned on, unlocks when ignition is turned off .
| Specifications |
- Current draw
<10mA average while armed
<150mA disarm (and for no more than 39 seconds after ignition is switched off).
- Operating voltage
Operating voltage +9VDC to +15VDC.
- Operating temperature
-20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin.
- Operating temperature
-20 degrees to +105 degrees for equipment designed to be installed inside engine compartment.
- Polarity protection
Accidentally reversing the battery leads will not damage the system.
- Independent indicator power fuse
System uses independent fuse to power indicators, ensures short circuit in indicator circuit does not affect system operation.
- Short circuit protection
Fuse protected in case any high power wiring is sheared through and shorted circuited.
| Convenience Functions |
- Panic / Car Finder
Press and hold second button of remote control to cause horn to sound and indicators to flash .
- Electric window closer
Provides signals used by electric window closers, system will close all electric windows when armed by remote control .
- Electronic boot release
Press and hold the secondary remote control button, while system is disarmed, to activate boot release output. The indicators will flash four time each time the boot release signal is sent  .
| Warranty |
- Manufacturers warranty on Control module
Guarantees control module is free from manufacturing defects for 24 months from time of purchase  .
- Manufacturers warranty on Sundry items
Guarantees remote controls, siren and sundry items are free from manufacturing defects for 12 months from time of purchase .
| Standards Compliance |
- Manufactured in ISO9001 facility
Built within world standard production facility.
NOTES LEGEND:
Will categorically need extra hardware and connections.
May require additional hardware or connections.
Additional relay and connection required in vehicles with boot solenoid. Relay and solenoid kit required for vehicle without solenoid.
 Vehicle circuit polarity may require addition components to convert voltage.
 Special order required - this is not part of the standard hardware.
 Special feature out of Dynamco's control.
Conditions apply.
Feature is a programmable option.
|